Slopes and Erosion

What to backfill a culvert with?

What to use around a culvert pipe: clean, compacted granular fill such as crushed stone or gravel, what to avoid, and why local specs matter.

On this page
  1. Short answer
  2. Follow the spec first
  3. Bedding, haunches and cover
  4. Materials commonly used
  5. Materials to avoid
  6. Compaction
  7. After backfill: protect the surface and ends
  8. When to hire a pro

Short answer

Culverts are generally backfilled with clean, granular, well-compacted material such as crushed stone, gravel or a sand and gravel mix, placed in thin layers around the pipe. Avoid large rocks, clay lumps, frozen soil, topsoil, and organic material close to the pipe. The exact material and method depend on the pipe type, depth, traffic loads and your local requirements, so check those before you buy anything.

Follow the spec first

A culvert under a driveway or road carries load and water, so there are usually requirements. The pipe manufacturer publishes installation instructions, and many local governments and road authorities set their own standards and may require a permit or inspection, especially for pipes under public roads or in a roadside ditch. Ask your local public works or roads department. Where a local spec and general advice differ, follow the spec.

Bedding, haunches and cover

Think of the fill in three zones:

  • Bedding under the pipe. A firm, even base of granular material that supports the pipe along its length. Soft spots and large stones under the pipe can cause it to settle or crack.
  • Haunches and sides. Fill beside the pipe, up to about its midpoint and beyond, needs to be placed and compacted by hand or with small equipment. This is the step most often done badly, and flexible pipe in particular depends on firm side support.
  • Cover. Fill above the pipe protects it from loads. The pipe maker or local authority specifies minimum cover, which varies with pipe type and traffic.

Materials commonly used

  • Crushed stone or clean gravel, often in a modest size range, which compacts well and drains freely.
  • Sand and gravel blends or other granular fill that meets local specs.
  • Native soil in some cases, if it is free of large stones, roots and debris and the spec allows it. It is more often used higher up, in the cover zone.

Materials to avoid

  • Large rocks or concrete rubble right against the pipe
  • Heavy clay that stays wet or shrinks and swells
  • Topsoil, mulch or organic matter, which settles as it rots
  • Frozen or very wet soil
  • Mixed construction waste

Compaction

Compaction matters as much as the material. Fill is generally placed in thin layers, called lifts, and compacted each time, rather than dumped and tamped at the end. Loose fill leaves voids that water can wash through, which can undermine the pipe and the driveway above it. Take particular care at the ends, where flowing water can scour fill from around the pipe.

After backfill: protect the surface and ends

When to hire a pro

A culvert under a road, a large pipe, or one in a watercourse is not a casual DIY job. Sizing the pipe, setting its slope and bedding it properly affect flooding and road safety. A local excavation contractor or engineer can handle both the design and any permits.

The complete guide to slopes and erosion

Ground Cover for Steep Slopes and Erosion Control
Read the guide

Keep exploring

Guides from other topics

All topics →